Advanced Topic
Warning - this is an advanced topic. Always backup your data first.
Erweitern des Stores mit LVM
Die meisten Linux / CentOS Installationen von uns arbeiten mit LVM. Dies kann man - vorausgesetzt das System erkennt eine Plattenvergrößerung oder neue Platte, wie folgt erweitern. Hier die Prozedur für eine Plattenerweiterung.
Schritt 1 - Feststellen der aktuellen config
# If the machine has not yet been rebooted, the SCSI bus can be scanned to detect new disks with the following command # Ggf - falls mehrere SCSI Adapter vorhanden sind host0 mit host1 oder host2 ... nochmals probieren bis die Platte gefunden wird echo "- - -" > /sys/class/scsi_host/host0/scan # Show free space df -h # Show partitions fdisk -l # Show hard drives ls /dev/sd* # View physical volumes managed by LVM lvm pvs # Display logical volumes managed by LVM lvm lvs # Display logical volume groups managed by LVM lvm vgs # Where is what mounted mount
Die Informationen oben werden nun unten gebraucht.
Schritt 2 - Anlegen einer neuen Partition
Hier ist es erforderlich, dass man weiß, wo der zusätzlicher Platz zu finden ist. Es gibt 2 Varianten - entweder eine neue Platte, oder eine erweiterte Platte.
In beiden Fällen, wird eine neue Partition angelegt. Hier in diesen Beispiel, wurde die bestehende Platte erweitert. Falls eine neue Platte hinzugefügt wurde, dann ist es auf /dev/sdb oder /dev/sdc etc. zu finden.
Die Befehle unten sowie die Partitionsnummer (bei einer neuen Platte ist die Partition dann 1), entsprechend anpassen.
fdisk /dev/sda # --> Edit the partitions on /dev/sda n # --> Create new partition p # --> New primary partition 3 # --> Create new partition 3 (view output at fdisk -1 above) Enter # --> Confirmation that the first available cylinder should be used Enter # --> Confirmation that the last available cylinder is to be used (gives the maximum size in total) t # --> Change partition type 3 # --> Edit partition 3 8e # --> Linux LVM w # --> Write reboot now
Schritt 3 - Hereinnahme in LVM - Device Erzeugen
# Here is the previous output of /dev/sd* --> this is the new disk (the 3rd partition on /dev/sda, the first disk) lvm pvcreate /dev/sda3
Schritt 4 - Volume Group erweitern
# Here we need the output of lvm vgs - the name of the volume group lvm vgextend "vg_testdb5" /dev/sda3
Schritt 5 - Logical Volume erweitern
# Here the output of lvm lvs is needed - the name of the logical volume - this is combined with the vgs to create the path to the device lvm lvresize -l +100%FREE /dev/vg_testdb5/lv_root
Schritt 6 - File System erweitern
# Same path as previous command resize2fs /dev/vg_testdb5/lv_root
# Mount Point from fstab xfs_growfs /srv/jtel/shared
Schritt 7 - Endergebnis prüfen!
df -h